How to reverse the effect of SAP
It is possible to reverse the effect of the super absorbent polymer (SAP) See below
Basically there are 3 ways;
1- Dry the product - at this time it can be reused
2- Mix with salted water (or add salt and stir). The water will come out of the gel but the water will remain sticky
3- Mix with acid. The polymers should then disintegrate -but note that Recyc PHP has never done this test.
Related Articles
SAP antibacterial effect
1. Does your gelling agent have antibacterial effect? No it does not, but it has a certain effect on bacterias, it does not spread since it gets stuck in the gel.
How to calculate required SAP for dredge sediment solidification
Information needed to enable us to calculate required SAP Quantity of water mixed with the sediment. Note: Very often people don't have this info. If it is the case, we need the following info to calculate the quantity Quantity of sediment to ...
How long does it take for SAP to dry- Recyc PHP inc
There are too many factors to consider when determining drying time (room temperature, added heat, dry or humid environment). But the tests that Recyc PHP inc made in an oven at 100 Celsius seemed to show that it took 1.5 times longer to dry 100 ml ...
Impact of the SAP in the Toxicity Charactheristic Leaching Procedure (TCLP)
Here is the info we know about this procedure. Our infos are based those documents: EPA - US Environmental protection agency - TCLP Method 1311 EHSO - Environment, Health and Safety Online - Hazardous waste fact sheet TCLP In the EPA document, The ...
SAP used in Ice pack
We have run testing on icepack prototypes comparing surface temperature. The prototypes were made with a poly film 4 mil envelope with different contents. The frozen products were laying flat on an open mesh surface in a 17 deg C environment. The ...